How to Fit 2015 WRX / STI Air Vents into a 10-Inch Android Head Unit Bezel
The 2015 WRX's center vents don't clip into the 10-inch Android head unit bezel. Shave the bottom of each vent clip until it slides in, then press it in snug. No glue needed, and the stock bezel is left alone.
Full video (4 min): Ep 25.5: Vent Retro fit into the Android 10 inch head unit for Subaru WRX STI FORESTER · John's YouTube channel
Get the parts
- Rotary tool (for shaving the vent clips): Generic pickGeneric pickSearch on Amazon ↗
- Plastic trim tool set: Generic pickGeneric pickSearch on Amazon ↗
As an Amazon Associate I earn from qualifying purchases. Some links are affiliate links.
Yes — you can install This kit on the 2015 WRX / STI center air vents going into an aftermarket 10-inch Android head unit bezel with a 4 min DIY job. The 2015 WRX's center vents don't clip into the 10-inch Android head unit bezel. Shave the bottom of each vent clip until it slides in, then press it in.
Overview
With the 10-inch Android head unit in John's 2015 WRX, the last piece was the center air vents. 2016 and 2017 vents are said to be a direct swap, but the 2015 vents don't fit the bezel's clips. An unmodified vent hits the bottom of the opening and won't go in. John shaved the bottom of the vent down until it fit. It isn't perfectly snug, but once it's in you can press it into place and it stays. The vents still tilt up and down, and they sit a little lower than stock, which doesn't bother him. No glue is needed, and you only trim the vents, so you can go back to stock by buying new vents from Subispeed or the dealer (make sure you get the right part number). John also reminds you to plug the climate control unit back in before closing the dash.
Vehicle & fitment
- Product
- Your existing 2015 WRX / STI center air vents, trimmed to fit the head unit's bezel
- Shown on
- John's red 2015 Subaru WRX with a 10-inch Android head unit (also applies to the STI and Forester bezels the video title lists)
- 2015 WRX / STI center air vents going into an aftermarket 10-inch Android head unit bezel
- Per John, 2016 and 2017 vents are said to drop straight in. The 2015 vents need shaving
Always confirm fitment for your exact year and trim with the seller before buying.
Tools & parts
Tools
- Rotary tool, file or sandpaper to shave the vent
- Plastic trim tool
Parts
- Stock 2015 WRX / STI center vents (trimmed)
Step by step
- 1
The problem▶ 0:00
2016–2017 vents are said to fit the bezel directly, but 2015 vents don't clip in.
- 2
Shave the vent▶ 0:14
Shave down the bottom of the vent where it hits the bezel. John's shaved vent fits; the stock one won't go in.
Tip: Take off a little at a time and test-fit often.
- 3
Press it in▶ 1:19
Set the vents in loosely, then press them in until they're snug. No glue is needed.
- 4
Check function▶ 1:59
The vents still tilt up and down. They sit a little lower than stock.
- 5
Going back to stock▶ 2:16
If you need to undo it, buy new vents from Subispeed or the dealer, and make sure you get the right part number.
- 6
Reconnect the climate controls▶ 2:56
Make sure the climate control unit is plugged back in before you close up the dash.
Get the parts
- Rotary tool (for shaving the vent clips): Generic pickGeneric pickSearch on Amazon ↗
- Plastic trim tool set: Generic pickGeneric pickSearch on Amazon ↗
As an Amazon Associate I earn from qualifying purchases. Some links are affiliate links.
FAQ
What vehicle does this head unit fit?
It is shown for the 2015 WRX / STI center air vents going into an aftermarket 10-inch Android head unit bezel. Per John, 2016 and 2017 vents are said to drop straight in. The 2015 vents need shaving Always confirm your exact year, trim and factory audio with the seller.
How long does the install take?
John's full video is 4 min. Plan on that much time for a careful DIY install, plus extra if you are new to dash work.
What tools do I need?
Tools called out in the guide: Rotary tool, file or sandpaper to shave the vent; Plastic trim tool.
Does it support wireless CarPlay or Android Auto?
Check the product listing for wired vs wireless CarPlay / Android Auto before you buy; John shows what worked in the video.
Where do I get the parts?
Use the buy links on this page for the unit and any harnesses John used. Some links are affiliate links.
Is this beginner-friendly?
The guide breaks the job into 6 steps with timestamps into the video. If you can remove trim panels carefully, you can follow along.
John's Subaru WRX
More photos →Photos from @ngooyen on Instagram. Follow for more.
Full transcript
Show the full transcript (23 lines) +
0:00all right so the next time lean part is the air vents so you have a
0:052016 or 2017 air vent they said it'll be able to be like an instant
0:10replacement these guys right here these are all have a 20 15 they do not fit
0:14I shaved it down I shaved it down on this one so it does fit but I'm
0:19I mean I mean nothing's confirmed yet because as you can see right here you see
0:27all that you know jaggedy hippity hopidus right there I shaved it down or
0:32then it fits it doesn't fit snug but it fits and then as you can see a year this
0:45is the non-modified one and if you try try to put it in it pretty much just me just
0:49hits that bottom part and it just does not fit it doesn't fit snug it's it sits
1:19I'm behind them and then get them to fit so I'll show you that right now all right,
1:25so once they're kind of in there you can just fit them to make it look good so
1:32let me just press it in so you can't live in there you loosely and then you
1:35just kind of snug it in so you can see they're kind of snugged in there and they
1:59work up and down so they- so they work it's just whether as you can see there there are a
2:09little bit they sit a little bit lower but that doesn't bother me that's how you
2:16get your fans fixed in a pinch if not you can buy in your new new fans from
2:21Subispeeds or the dealership make sure you get the right number because that'll
2:26be problematic but um yeah so those were the vents that's uh I just plugged
2:56make sure you plug in the you heard her a controller unit to mine's plugged in so a the
3:09but uh- yeah I didn't want it to rub too bad because it is a pretty aggressive offset
3:16so it does poke out a little bit that's why I got the mudflaps for my car
3:25because you don't want it to uh have a lot of sling onto your car so yeah that's a little
3:33close look on the nto 3s sbc's
Machine-transcribed from the full-length video and lightly cleaned (product names fixed). Watch the video for exact wording.
Next step








